Shaftless Butt Splicers

For the wide web heavy board industry

Model Shown: ZH3272-05 Shaftless Automatic Butt Splicer for Heavy Board

• Key Features

  • Zero Gap Butt Splice Guarantees no Overlap Splicing
  • Two Sided Tape Application for Maximum Splice Strength
  • Shaftless Turret Design for Full Width Roll Support
  • Automatic Microprocessor with Distributed Computer Control
  • Fully Automatic Splice Cycle 
  • Easy, Single Method Splice Preparation Assures Reliable Splicing
  • Bi-Directional Unwind Capability
  • System Diagnostics

• Options:  

  • In-Register Splice System For Pre-Printed or Pre-Punched Webs

• Utility Requirements

  • Electrical: 230/460 VAC, 3 phase, 60hz
  • Pneumatic: 80 PSI

• Specifications

  • Web Width: up to 40 inches (1016 mm)
  • Roll Diameter: 72 inches (1828 mm)
  • Splicing speed : Up to 1000 fpm (304 MPM)
  • Material: Up to 32 pt Board
  • See our spec page for specs more specific to your requirements.

Zero Gap Butt Splice

The heart of the system is the ZERO GAP butt splice unit. During the splice cycle, both webs are severed simultaneously, producing expiring web cut-off and new web lead edge trim in one motion.

Back to Top

Shaftless Turret Design

Trying to load an out of round core on to a cantilevered shaft is eliminated, thanks to KTI's "shaftless" turret. Rolls are loaded directly from the floor from the same position each time. The core chucks only engage into the core a few inches, eliminating the need to force a core shaft through the entire core.