Shaftless Butt Splicers

For the Folding Carton and Light Board Industry

Model Shown: KTI  ZL2272-05, Two Piece Butt Splicer for Light Board

• Key Features

  • Zero Gap butt splice
  • Two-sided tape application for maximum splice strength
  • Easy single-method splice preparation assures reliable splicing
  • Shaftless turret design for full roll support
  • Heavy duty construction
  • Fully automatic splice cycle
  • Easy roll loading from floor
  • Automatic roll sidelay
  • Automatic microprocessor control

• Options

  • Automatic In-Register Splicing
  • Automatic Rolling Element Decurler up to 26 inch width
  • Web Guides

   

• Utility Requirements

  • Electrical: 230/460 VAC, 3 phase, 60hz

  • Pneumatic: 80 PSI

• Specifications:

  • Web Width: up to 50 inches (1270 mm)
  • Splice speed: Up to 1000 FPM (304 (MPM)
  • Roll Diameter: 72 inch (1828 mm)
  • For Up to 24 pt Paperboard and Many Other Materials
  • Click here for detailed specs

Easiest Splice Preparation Available

Splice preparation is not dependent on the operator correctly positioning the leading edge of the new roll. This is automatic with our splicer.

Shaftless Turret Design

Trying to load an out of round core on to a cantilevered shaft is eliminated, thanks to KTI's "shaftless" turret. Rolls are loaded directly from the floor from the same position each time. The core chucks only engage into the core a few inches, eliminating the need to force a core shaft through the entire core.

Back to Top

Model Shown: KTI  ZL2672-05, Three Piece Shaftless Butt Splicer for Light Board

Automatic Roll Sidelay

This helps keep the running web correctly aligned going into the press without the operator having to continue to manually adjust alignment.

KTI also offers shaftless butt splicers for heavy board.