• Key Features

  • Zero-Gap Butt Splice Guarantees No Overlap Splicing
  • Heavy Duty Construction
  • Fully Automatic Splice Cycle
  • System Diagnostics
  • Two Sided Tape Application
  • Automatic Leading Edge Trim
  • Automatic Tape Edge Trim
  • Low Riding Festoon
  • Automatic roll sidelay
  • Automatic microprocessor control

   

• Available Options

  • Automatic In-Register splicing
  • Automatic Decurler
  • Roll Loading Cart
  • Web Guides

• Utility Requirements

  • Electrical: 230/460 VAC, 3 phase, 60hz
  • Pneumatic: 80 PSI

Model Shown: KTI ZC1640-05 "Cantilever" Butt Splicer

• Specifications

  • Web Width: up to 20 inches (508 mm)
  • Roll Diameter: 40 inch (1016 mm) or 50 inch (1270 mm)
  • Splice Speed: Up to 1000 FPM (304 MPM)
  • Material: Paper, label, Tag, and many other specialty materials
  • For detailed specs click here

Low Riding Festoon

When unwinding paper before the splice diameter is reached, the moving rollers in the festoon run approximately 3 feet above the floor. This minimizes web span related problems such as wrinkling and web weave. It also allows a high speed panic stop rate without subjecting the core to excessive torque which can sometimes cause roll-to-coreshaft slippage. Just before the splice, the festoon slowly rises to the top allowing full use of available storage.

Back to Top

Excess Tape Trim

Excess tape is trimmed utilizing dual rotary cutters. Incorporating the servo controlled sidelay, the parent material is not cut during the trim process allowing full use of the web.

Splice Head

Simple, easy-to-prep splice head guaranteed no overlap of webs at splice joint. This totally eliminates impression problems and jam-ups caused by partially lapped splices. During splice cycle, leading edge of new web is automatically trimmed and removed to assure a precise, zero-gap butt splice. The primary splice tape is always applied to the top side of the web. An optional second-side tape applicator is available.