ZL Series Shaftless Butt Splicers

• Key Features
  • Zero Gap butt splice
  • Two-sided tape application for maximum splice strength
  • Easy Single-method splice preparation assures reliable splicing
  • Shaftless turret design for full roll support
  • Heavy Duty construction
  • Fully automatic splice cycle
  • Easy roll loading from floor
  • Automatic roll sidelay
  • Automatic microprocessor control

• Options
  • Automatic In-register splicing
  • Automatic rolling element decurler up to 26" width
  • Web Guide
• Utility Requirements
  • Electrical 230/460 VAC, 3 phase 60hz
  • Pnuematic 80PSI

• Specifications:
  • Web Width: up to 50" (1270 mm)
  • Splice Speed: up to 1000 FPM (304 MPM)
  • Roll diameter: 72" (1828 mm)
  • For Up to 24 pt paperboard and many other materials

Easiest Splice Preparation Available

Splice preparation is not dependent on the operator correctly positioning the leading edge of the new roll. This is automatic with our splicer.

Shaftless Turret Design

Trying to load an out of round core on to a cantilevered shaft is eliminated, thanks to KTI's "shaftless" turret. Rolls are loaded directly from the floor from the same position each time. The core chucks only engage into the core a few inches, eliminating the need to force a core shaft through the entire core.

Automatic Roll Sidelay

This helps keep the running web correctly aligned going into the press without the operator having to continue to manually adjust alignment.