Home
KTI Products
KTI Profile
KTI Directory
KTI Sales Team
Contact KTI
Directions to KTI
Online Brochures
KTI Links
In The News
Trade Shows

 

 

JL Cantilever Butt Splicer

For Label Applicators

Increase Labeling Efficiency up to 20%
KTI has taken another step in the development of splicing equipment. We're offering a new model of butt splicer specifically developed for use with label applicating equipment. This compact splicer was designed to meet the specific requirements of processes that apply labels. The JL Series Cantilever Butt Splicer eliminates multiple operator steps associated with competitive units. Productivity is increased and waste is substantially reduced.

Model Shown: JL 0620-R

 

  • Specifications

    • Web Width up to 10"

    • Splice Speed: Up to 500 FPM (152 MPM)

    • Roll Diameter: 20, 24, or 30"

    • Material: PS, Film Labels, and Paper

  • Standard Features

    • Designed for use with Label Applicator Equipment

    • Zero Gap Butt Splice Guarantees No Overlap Splicing

    • Cuts Through Both Webs Simultaneously

    • Tape Applied to Same Side of Web Every Time

    • Automatic Leading Edge Trim

    • Splice Between Labels

    • In-Register Splice System for Pre-Printed Labels

    • One Piece Cantilever Turret Design

    • Small Footprint Requires Minimum Floor Space

    • Fully Automatic Splice Cycle

  • Options

    • Zero-Tension Infeed

    • Right Angle Turn Bar

    • Adaptors for Various Core Sizes

    • Roll Loading Cart

  • Utility Requirements

    • Electrical: 115 VAC, Single phase, 60hz

    • Pneumatic: 80 PSI

For more information, contact our sales department.
 
Copyright © 1995-2008 KTI. All rights reserved.     An American Company
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.
Send mail to info@keenetech.com with questions or comments about this web site.
Last modified: October 09, 2008